Floor Securing; Wiring Of Cables; Specifications - NEC NP01TK Installation And Adjustment Manual

■ Floor securing

There are four M5 floor securing bolt holes in the U-shaped bracket for securing the mounting
unit for table projection to a floor so as to prevent the projector from falling over. Use these in
conjunction with the installation environment.
The screws are provided by the customers themselves.
See page ENG-3 for the hole positions and dimensions.

■ Wiring of cables

(1) Pass the cables through the wiring port and connect them to the projector. Lay the cables
next to the slide arm at this point.
Upon finishing the wiring, attach the projector cable cover. Refer to the user manual of the
projector.
CAUTION
• Ensure the cables are of sufficient length taking into consideration the extension and con-
traction when adjusting the sliding.
• Be sure to pass the cables through the cable wiring port. If the wiring is not done correctly,
they may result in the projector falling over.
WARNING
• Do not pass the cables through the center of the slide arm. The power and oth-
er cables may get entangled and damaged by the internal metal fittings when
moving up and down, resulting in a risk of fire and electric shock.

Specifications

Product name:
Model name:
Amount of vertical movement:
Projection direction:
External dimensions:
Weight:
These specifications and the design are subject to change without notice.
Mounting unit for table projection
NP01TK
142 mm
Downward projection, upward projection
396 (W) × 188 (D) × 565 (H) mm
Approx. 9 kg
ENG-7
U-shaped bracket
Anchor bolt securing example
Cable wiring port