Ricoh CL7000 - Aficio D Color Laser Printer Maintenance Manual page 74

Troubleshooting
Messages/Second messages
Load Correct Size Paper
/Press # To Continue
Load Paper Tray #
Load Paper
4
/Paper Size: Paper Type:
Menu Protected Cannot
Change
No Files Exist
Paper Invalid for Du-
plex:Tray#
/Change Setting or Form
Feed
Punch-hole Chips are Full
68
Causes
The paper size setting in the
tray differs from that of the ac-
tual paper size in the tray.
The indicated tray is out of pa-
per. #: tray number
1:The printer received a re-
quest for a paper type, or pa-
per size not supported by
printer, and Tray Locking is
not applicable.
2:The paper type and size
loaded in the tray which the
printer searched using Tray
Locking is invalid for Duplex
Print.
The menu is protected and the
setting cannot be changed.
There are no files available for
Sample Print job or Locked
Print job.
The printer detected the set-
ting of the indicated tray is in-
valid for Duplex Tray. #: tray
number
The Punch Chips container is
full of punch chips.
Solutions
Load {paper size} paper in the
selected feed direction into the
tray, and then change the pa-
per size with the control pan-
el.
Or, press { { { { Form Feed} } } } , and se-
lect the tray with the control
panel.
Or, press { { { { Job Reset} } } } to cancel
the print job.
Load paper into the indicated
paper tray.
Change the setting of the indi-
cated paper input tray, or
press { { { { Job Reset} } } } . Form Feed
is not possible here.
Wait for two seconds until the
previous display appears.
Wait for two seconds until the
previous display appears.
Change the setting of the indi-
cated paper input tray, or ap-
ply Form Feed using another
tray, or press { { { { Job Reset} } } } .
Empty the punch waste box.
See p.95 "Removing Punch-
hole Chips".
If the message appears the
punch waste box is not full, re-
move the Punch-hole chips on
the top of the punch waste
box.
See p.95 "If the message ap-
pears even after removing the
Punch-hole chips".