Ricoh CL7000 - Aficio D Color Laser Printer Maintenance Manual page 52

Paper and Other Media
❖ ❖ ❖ ❖ Thick Paper
• Use the bypass tray
• The bypass tray can hold up to 135 kg (163 g/m
quality on thicker paper cannot be guaranteed.
• Check that the top of the stack is not higher than the limit mark inside the tray.
• When printing on thick paper, select thick paper mode using the printer
driver.
• When printing on the reverse side of plain paper that is already printed on,
you should load it on the bypass tray and select [Thick (Duplex Backside)]
from [Paper Type:] using the printer driver.
3
Note
❒ The number of sheets that can be set may vary depending on paper
thickness and type.
❖ ❖ ❖ ❖ OHP transparencies
• When printing on OHP transparencies, use the bypass tray.
• Load OHP transparencies on the tray with the print side over, otherwise
they may stick to the fusing unit and cause a misfeed.
• Remove unused OHP transparencies from the bypass tray after you are
finished printing. They may stick together if left in the tray.
• When printing on OHP transparencies, you should select the OHP trans-
parency mode using the printer driver.
• Check that the top of the stack is not higher than the limit mark inside the tray.
• When printing multiple OHP transparencies, remove each sheet from the tray
one by one before the next is printed out, or select [Slip Sheet] in the printer
driver. For details about using "Slip Sheet", see the printer driver Help.
❖ ❖ ❖ ❖ Envelopes
Important
❒ Only envelopes A and B as shown below are supported.
Misfeeds might also occur when using envelopes A and B depending on the
*1
length and shape of the flaps.
46
2
) of paper weight. Print
*1
Supported
*1
Supported
Not supported