Ricoh CL7000 - Aficio D Color Laser Printer Maintenance Manual page 70

Troubleshooting
Messages/Second messages
Hardware Problem DIMM
Hardware Problem Ethernet
Hardware Problem Finisher
4
Hardware Problem HDD
64
Causes
The printer identified a DIMM
sum value error.
The printer identified an
Ethernet error.
There is a problem with the
finisher.
The printer identified a HDD
board error.
Solutions
Remove and re-install the
DIMM correctly.
Remove any dust under the
DIMM.
If the message appears again,
contact your sales or service
representative.
See "Setting Up", Setup Guide.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Turn the power off, and then
on. Remove and re-install the
finisher correctly. If the mes-
sage appears again, contact
your sales or service represen-
tative.
See "SR770 (2 Tray Finisher)",
Setup Guide.
Turn the power off, and then
on.
Remove and re-install the
HDD board correctly.
If the message appears again,
contact your sales or service
representative.
See "Printer Hard Disk Type
7000", Setup Guide.