Enabling The Infrared Sensor - Dell Inspiron 4100 Solution Manual

HINT: You cannot use the
infrared sensor when the
computer is docked.
26
Se t t i n g U p
In Microsoft Windows Me
Right-click the Softex BayManager icon on the Microsoft Windows
1
taskbar.
Click Remove/Swap.
2
Wait a few seconds until the device is ready to be ejected.
3
Keep the display open, and tilt the computer back so that you can
4
access the bottom of the computer.
Slide and hold the latch release, and pull the device out of the module
5
bay.
Insert the new device into the bay, and push it until you hear a click.
6
Click OK. Then click OK again to close the Softex BayManager
7
window.
In Microsoft Windows 2000
Double-click the Unplug or Eject Hardware icon on the Microsoft
1
Windows taskbar.
Click the device you want to eject and then click Stop.
2
Click OK, and wait until the device you want to eject is cleared from
3
the list of devices in the Unplug or Eject Hardware window.
Keep the display open, and tilt the computer back so that you can
4
access the bottom of the computer.
Slide and hold the latch release, and pull the device out of the module
5
bay.
Insert the new device into the bay, and push it until you hear a click.
6
When Windows recognizes the new device, click Close.
7

Enabling the Infrared Sensor

Turn on your computer, and enter the system setup program by
1
pressing when the Dell™ logo appears.