Brother CP-2000 User Manual page 8

2. Setup
6
Attach the tray by sliding its slots on each sides of back of the tray
over the two brackets on the front of the copyboard above the printer.
b c
+
Folding up the stand
a
Do not allow young children to play on or near the copyboard when it is set up
on its stand.
To reduce the risk of the copyboard falling down and causing injuries, do not
loosen the knobs on the stand or pull the blue pin on the left leg while the stand
is in use.
1
Make sure the copyboard is turned off and the AC adaptor is unplugged.
2
Pull up on the tray to remove it, and then remove the paper from the
printer.
3
Lay the copyboard on the floor facing downward with the printer control
panel and writing surface positioned over a piece of cloth or other
protective sheet to prevent them from being damaged.
6
Do not subject the tray to strong impacts or use it in any way other than
for holding markers and erasers.
Remove the bubble wrap packaging covering the printer and writing
surface.