Brother CP-2000 User Manual page 13

3
Remove the stand by removing the six black screws numbered 1, 2 and
3 on each bracket that attaches the stand to the back of the copyboard.
+
To prevent the screws from being
lost, screw them back into the holes
on the back of the copyboard.
4
When mounting the copyboard vertically: Remove plates A, and then
use the same screws and holes to attach the enclosed wall-mounting
brackets.
When mounting the copyboard horizontally: Remove plates B, and
then use the same screws and hole to attach the enclosed wall-mount-
ing brackets.
B
+
Be sure to keep the removed plates in a safe place so that they can
be re-attached later if necessary.
A
B
A
2. Setup
11