Brother CP-2000 User Manual page 15

7
With the copyboard mounted on the wall, remove the two knobs on
the bottom of the unit, and then attach the long ends of the two
enclosed L-shaped brackets to the bottom of the unit with the two
knobs.
8
With the short ends of the L-shaped brackets against the wall, mark the
wall at the two points where the anchors will be installed, and then
remove the copyboard from the wall-mounting bar.
9
Install the two anchors as described in steps
ing the wall-mounting bar on page 9.
0
Remove the screws from the anchors, hang the copyboard back onto the
wall-mounting bar, and then attach the L-shaped brackets to the wall by
re-installing the screws, while making sure to use the enclosed washers.
a
Regularly check that the copyboard is securely mounted to the wall in
order to reduce the risk of the copyboard falling down.
c b
When removing the copyboard from the wall, also remove the L-shaped
brackets.
-
Attach the tray by sliding its slots on each sides of back of the tray over
the two brackets on the front of the copyboard above the printer.
c b
If the copyboard is mounted horizontally, the ends of the tray can be
pulled out to extend it.
Do not subject the tray to strong impacts or use it in any way other than
for holding markers and erasers.
2. Setup
2 4
through of Attach-
13