Brother CP-2000 User Manual page 12

2. Setup
4
Tighten each screw (by turning it clockwise)
approximately 20 turns.
a
5
Remove each screw.
6
Attach the wall-mounting bar to the wall by re-installing the screws
into the anchors, while making sure to use the enclosed washers.
a
Mounting the copyboard
1
Lay the copyboard on the floor facing downward with the printer
control panel and writing surface positioned over a piece of cloth or
other protective sheet to prevent them from being damaged.
2
Make sure that the stand is folded up.
+
10
The screws must be tightened by hand.
Do not use an electric screwdriver,
otherwise the copyboard may fall down.
Make sure that the bar is firmly attached to the wall, otherwise the
copyboard may fall down.
If the stand is still folded out, refer to page 6 for details on folding it up.