Brother CP-2000 User Manual page 16

2. Setup
Partition mounting
Follow the precautions below to mount the copyboard correctly on the partition
and reduce the risk of it falling down.
a
Before attempting to hang your copyboard on a cubicle wall, partition, or the like
("partition"), consult the manufacturer of the partition to verify that the partition
is capable of supporting the copyboard without adverse consequences.
The enclosed partition-mounting brackets allow you to hang the copyboard on a
standing partition 1.5 in. to 4 in. (38 mm to 102 mm) thick and sturdy enough to
withstand a weight of at least 77.3 lbs. (35 kg).
Do not install, adjust, or remove the partition-mounting brackets with the copyboard
hanging from the wall-mounting bar. Always remove the copyboard beforehand.
1
Attach the two fixed parts of the partition-mounting brackets to the wall-
mounting bar with the four enclosed screws.
2
Insert the ends of the movable parts of the
partition-mounting brackets into the fixed parts.
+
3
While holding the partition-mounting brackets
clamped around the top of the partition, tighten
the knobs.
4
Attach the two wall-mounting brackets to the back of the copyboard as
described in step
14
Either end of the movable part of the bracket
can be used depending on the width of the
partition. Insert the end stamped A if the
partition is 1.5 in. to 2.8 in. (38 mm to 71 mm).
Insert the end stamped B if the partition is 2.7
in. to 4 in. (69 mm to 102 mm).
4
of Mounting the copyboard on page 11.