Brother CP-2000 User Manual page 17

5
While holding both sides of the copyboard, hook the brackets at the back
of the copyboard onto the wall-mounting bar pegs.
a
Do not release the copyboard
until you are sure that it is
securely mounted on the wall-
mounting bar.
Do not push the unit upward
or to either side, otherwise it
may fall down.
6
Attach the tray by sliding its slots over the two brackets on the front of the
copyboard above the printer.
c b
Do not subject the tray to strong impacts or use it in any way other than for
holding markers and erasers.
Re-attaching the stand
1
Lay the copyboard on the floor facing downward with the printer
control panel and writing surface positioned over a piece of cloth or
other protective sheet to prevent them from being damaged.
2
Use the six screws (three on each side) to attach the stand to the back
of the copyboard by tightening the screws in order according to the
numbering on each bracket of the stand (1, 2, then 3).
+
While the stand is being used, it is recommended that the wall-mounting
brackets be removed in order to avoid that they be pulled on with excessive
force. After removing the wall-mounting brackets, re-attach the plates. Refer
to step
4
of Mounting the copyboard on page 11.
2. Setup
15