Brother CP-2000 User Manual page 19

Loading the paper
In order to print out what is written on the copyboard, paper must first be loaded in the
printer. The maximum diameter of the paper roll that can be installed in the copyboard is
2.6 in. (66 mm).
1
Open the paper compartment by pulling
up its latch.
c b
Do not open the paper compart-
ment while the unit is printing.
2
While gently pressing down on the center of the paper guide bar, insert
the roll of paper into the paper compartment.
+
The paper should unroll from the top and enough paper (about 8 in. (20 cm))
should be pulled out to allow it to be torn off easily.
If there is slack in the paper, tighten it by holding the core and pulling on the paper.
1
3
Release the bar while making sure that
the paper feeds over it, and then lift the
paper compartment cover with both
hands and firmly close it.
2
Be sure to pass the paper over the guide bar.
3. Operation
17