Table of Contents
Advertisement
v You can install only an optional diskette drive in bay 3. Other drives are not
v You can install SATA hard disk drives in bays 4 and 5 only.
v The integrated IDE controller supports the connection of up to two IDE devices.
v The electromagnetic interference (EMI) integrity and cooling of the server are
v For a complete list of supported optional devices for the server, see
Installing a CD or DVD drive
To install a CD or DVD drive in bay 1 or 2, complete the following steps:
supported in bay 3.
protected by having all bays and PCI or PCI Express slots covered or occupied.
When you install a drive or PCI or PCI Express adapter, save the EMC shield
and filler panel from the bay, or the PCI or PCI Express adapter slot cover in the
event you later remove the drive or adapter.
http://www.ibm/com/servers/eserver/serverproven/compat/us/.
1. Read the safety information that begins on page v and "Installation guidelines"
on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see "Removing the side cover" on page 9).
4. Remove the bezel (see "Removing the bezel" on page 10).
5. Use your fingers to press in on the drive-bay filler panel release tab on the
inside of the bezel and remove it from the bezel; then, pry the EMC shield
away from the server. Store the filler panel and EMC shield in a safe place.
Release tab
Chapter 2. Installing optional devices
15
Advertisement
Table of Contents
