Table of Contents
Advertisement
board. See "Power and signal cables for internal drives" on page 22 for
additional information about cabling drives and "System-board internal
connectors" in the User's Guide for the location of the SATA connectors on the
system board. If there are open connectors on the cables that connect existing
SATA drives, you can use these cables to connect the new drive.
14. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and DIMMs.
15. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 25.
Chapter 2. Installing optional devices
21
Advertisement
Table of Contents
