Table of Contents
Advertisement
Cabling an optional SCSI adapter
You can install an optional SCSI adapter in the server to control an internal tape
drive. You can also cable a SCSI adapter to external hard disk drives. See the
SCSI adapter documentation for complete instructions for installing a SCSI adapter
in the server and for additional information about SCSI adapters.
Note: A SCSI adapter and cable are required to connect external SCSI devices.
To cable an optional SCSI adapter, complete the following steps:
1. Install the SCSI adapter (see "Installing an adapter" on page 23).
2. Connect the SCSI signal cable to the adapter and to one or more of the
3. Complete the installation of the optional SCSI adapter (see "Installing an
Completing the installation
To complete the installation, you must reinstall the bezel, reinstall the side cover,
connect all the cables and, for certain optonal devices, run the Configuration/Setup
Utility program. Follow the instructions in this section.
Installing the bezel
To replace the bezel, complete the following steps:
1. Insert the two alignment tabs at the top of the bezel into the bezel retention
connectors on the rear of the SCSI devices.
adapter" on page 23).
slots at the top of the chassis.
SCSI cable
SCSI connector
SCSI adapter
Chapter 2. Installing optional devices
25
Advertisement
Table of Contents
