Table of Contents
Advertisement
Clear CMOS jumper (J19)
4. Move the boot block recovery jumper to pins 2 and 3.
5. Wait 30 seconds; then, connect the server to the ac power source.
6. Insert the BIOS flash diskette into the external diskette drive.
7. Restart the server.
8. When POST starts, select 1 - Update POST/BIOS from the menu that
contains various flash (update) options.
9. When you are asked whether you want to save the current code to a diskette,
type N.
10. Type 1 and press Enter to continue.
Attention:
Do not restart or turn off the server until the update is completed.
11. When the update is completed, turn off the server.
12. Remove ac power from the server.
13. Move the boot block jumper back to pins 1 and 2.
14. Wait 30 seconds; then, connect the server to the ac power source.
15. Replace the cover; then, restart the server.
BIOS recovery jumper (J22)
Boot block
jumper (J5)
Chapter 5. Solving problems
63
Advertisement
Table of Contents
