IBM LS20 - BladeCenter - 8850 Service Manual page 88

Standard-form-factor expansion card
To remove a standard-form-factor expansion card, complete the following
steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the cover (see "Operating the blade server cover" on page 64 for
5. Gently pivot the wide end of the card out of the expansion card connectors;
6. To remove the expansion card tray, remove the screws that secure it to the
74
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
on page 59.
blade server from the BladeCenter unit. See "Removing and installing the blade
server in a BladeCenter unit" on page 61 for instructions.
instructions).
Expansion card
Expansion
card tray
then, slide the notched end of the card out of the raised hook on the tray and lift
the card out of the blade server.
system board.