IBM LS20 - BladeCenter - 8850 Service Manual page 77

8. Make sure that the power-on LED on the blade control panel is lit continuously,
indicating that the blade server is receiving power and is turned on.
9. (Optional) Write identifying information on one of the user labels that come
with the blade servers and place the label on the BladeCenter unit bezel.
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the blade server (see the Installation and User's Guide for
information about the label placement).
10. If you have other blade servers to install, do so now.
Note: Reinstall the bezel assembly on the BladeCenter T unit after you have
finished installing the blade servers (see the BladeCenter T Types 8720 and
8730 Installation and User's Guide for detailed instructions for reinstalling the
bezel assembly).
If you have changed the configuration of the blade server, or this is a different blade
server than the one you removed, you must configure the blade server with the
Configuration/Setup Utility and you might have to install the blade server operating
system. Detailed information about these tasks is available in the Installation and
User's Guide.
Chapter 4. Removing and replacing blade server components
63