IBM LS20 - BladeCenter - 8850 Service Manual page 34

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 8850," on page 53 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
199 Processor power rating unsupported.
201 Memory test error.
229 Cache error.
289 DIMM disabled by user or system.
20
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
Action
1. (Trained service technician only) Make sure that
the microprocessor that was just installed has a
supported power rating. If the power rating is not
supported, replace the microprocessor with one
that has a supported power rating.
2. Update BIOS code.
3. (Trained service technician only) Replace the
microprocessor.
1. Update BIOS code and rerun diagnostics.
2. Reseat the DIMMs.
3. Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. DIMMs
b. (Trained service technician only) System
board assembly
1. Reseat the following components:
a. (Trained service technician only)
Microprocessor 1
b. (Trained service technician only)
Microprocessor 2
2. Replace the components listed in step 1 one at a
time, in the order shown, restarting the server
each time.
1. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable
the DIMM.
2. Reseat the disabled DIMM.
3. Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. Disabled DIMM
b. (Trained service technician only) System
board assembly