To install a replacement SCSI hard disk drive, complete the following steps.
Hard drive
release lever
1. Identify the location (SCSI ID 0 or SCSI ID 1) in which the hard disk drive will
2. Place the drive into the hard disk drive tray and push it toward the rear of the
3. Install the blade server cover (see "Operating the blade server cover" on page
4. Install the blade server into the BladeCenter unit. See "Removing and installing
68
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
SCSI ID 1
SCSI ID 0
Hard drive
release lever
be installed.
Attention:
Do not press on the top of the drive. Pressing the top could
damage the drive.
drive, into the connector until the drive moves past the lever at the front of the
tray.
64 for instructions).
the blade server in a BladeCenter unit" on page 61 for instructions.