Configuration File Management - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
Download the new software file from NETGEAR, save it to your hard disk, and unzip it.
1.
From the main menu Management section, click the Upgrade Firmware link to display the
2.
screen above.
In the Upgrade Firmware menu, click the Browse button and browse to the location of the
3.
image (.IMG) upgrade file.
Click Upload.
4.
When the upload completes, your wireless access point will automatically restart. The upgrade
process typically takes about one minute.
In some cases, you may need to reconfigure the wireless access point after upgrading.

Configuration File Management

The WG102 Access Point settings are stored in the wireless access point in a configuration file.
This file can be saved (backed up) to a user's computer, retrieved (restored) from the user's
computer, or cleared to factory default settings.
From the main menu Management heading, click the Backup/Restore Settings link to bring up the
menu shown below.
Figure 4-4: Settings Backup menu
The three options displayed are described in the following sections:
4-6
202-10064-02, June 2005
Management