Front Panel - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Front Panel

Figure 2-1: WG102 front panel
Viewed from left to right, the WG102 Access Point provides these four status LEDs: PWR, TEST,
LAN, and WLAN. The following table explains these LED indicators:
LED DESCRIPTION
PWR Power Indicator
Off No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 4, Troubleshooting.
On Power is on.
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
LAN Ethernet link indicator
Off No connection detected on the Ethernet link
Amber On Indicates 10 Mbps Ethernet link detected
Amber Flashing Data is being transmitted or received on the 10 Mbps Ethernet link
Green On 100 Mbps Fast Ethernet link detected.
Green Flashing Data is being transmitted or received on the 100 Mbps Ethernet link
WLAN Wireless LAN Link Activity Indicator
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
2-6
202-10064-02, February 2005
Introduction