How To Configure Wpa And Wpa2 - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
Click WEP/WPA Settings in the Security menu of the WG102.
2.
Figure 3-17: WEP/WPA Settings menu
Choose WPA2-PSK from the list.
3.
Enter the pre-shared key passphrase.
4.
Click Apply to save your settings.
5.

How to Configure WPA and WPA2

Note: Not all wireless adapters support WPA. Furthermore, client software is required on the
client. Windows XP and Windows 2000 with Service Pack 3 do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
Note: Not all wireless adapters support WPA2. Furthermore, client software is required on the
client. Make sure your client card supports WPA2. Consult the product document for your wireless
adapter and WPA2 client software for instructions on configuring WPA2 settings.
Basic Installation and Configuration
202-10064-02, June 2005
3-29