Default Factory Settings - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Default Factory Settings

When you first receive your WG102, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
"WG102 front panel" on page
User Name (case sensitive)
Password (case sensitive)
Broadcast Network Name (SSID)
802.11g Radio Frequency Channel
AutoCell RF Management
AutoCell Enhanced RF Security
Restricting connectivity based on MAC Access
Time Zone Adjust for Daylight Saving TIme
Basic Installation and Configuration
2-6.
FEATURE
Operating Mode
Access Point Name
Built-in DHCP client
IP Configuration
Network Name (SSID)
WEP/WPA
Control List
Time Zone
SNMP
202-10064-02, June 2005
FACTORY DEFAULT SETTINGS
admin
password
Access Point
netgearxxxxxx where xxxxxx are the last six digits of
the wireless access point's MAC address
DHCP client disabled, it uses the default IP address
IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR
Enabled
Auto
Disabled
Enabled
Disabled
Disabled
GMT
Disabled
Disabled
3-3