Treatment Against Environmental Condition - KIP 7100 User Manual

1. 7. 3

Treatment against environmental condition

Take a necessary treatment according to the environmental condition as shown below.
Humidity(%) Possible problem
Low "Void of image", "crease of paper" and
other problems occurs when you print
with plain paper and tracing paper.
"Void of image" occurs when you print
with tracing paper.
40%
70%
"Void of image" occurs when you print
with plain paper and tracing paper.
"Void of image", "crease of paper" and
other problems occurs when you print
with plain paper and tracing paper.
High
NOTE
(1) KIP 7100 is equipped with the Dehumidify Heater (optional for the US).
Using it in high humidity environment (65% or higher) is recommended.
Refer to [2.9 Dehumidifying Roll Paper].
(2) "Void of image" and "crease of paper" will occur in case of extremely high or low
humidity.
Normal Print
Normal Print
Necessary treatment
1. Install the humidifier in the room, and
humidify the room air.
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
Remove the paper from the machine after
everyday use, and keep it in a
polyethylene bag.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
1. Turn on the Dehumidify Heater.
(if installed)
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
If the media is humidified;
If the media is humidified;
1-16
Crease of paper
Loss of image
Chapter 1 Before Use