Fault Codes - Maytag MER6875BAS - Convection Double Oven Range Use And Care Manual

To cancel the Clock display:
If you do not want the time of day to display:
Press and hold the upper oven CANCEL and
Clock pads for three seconds. The time of day
will disappear from the display.
When the clock display is canceled, press the
Clock pad to briefly display the time of day.
To restore the Clock display:
Press and hold the upper oven CANCEL and Clock pads for
three seconds. The time of day will reappear in the display.
Timer
Each timer can be set from one minute (00:01) up to 99 hours
and 59 seconds (99:59].
The timers can be used independently of any other oven
activity. They can also be set while another oven function is
operating.
The Timers do not control the oven.
To set the Timer 1 or 2:
1. Press the Timer 1 or 2 pad.
• 00:00 and TIMER 1 or 2 flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
• The colon and TIMER 1 or 2 will continue to flash.
• TIMER 1 or TIMER 2 will be displayed. If both timers are
active, TIMER 1 and TIMER 2 will be displayed.
3. Press Timer pad again or wait four seconds.
° The colon stops flashing and the time begins counting
down.
• The last minute of the timer countdown will be displayed
in seconds.
4. At the end of the set time, one long beep will sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancel the Timer:
1. Press and hold tile corresponding Timer pad
for three seconds.
OR
2. Press the Timer pad and press '0' using
the number pads.
0
Locking the Control
and Oven Doors
The touchpad and oven doors car/be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If an oven is currently in use, the touchpads and doors cannot
be locked.
The current time of day will remain in the display when the
touchpads and doors are locked.
To lock both doors:
1. Press and release CANCEL pad.
2. Press and hold the upper oven CANCEL and
Cook & Hold pads for three seconds.
• OFFappears in the display
° LOCK flashes while the doors are locking.
Both oven doors lock. LOCK remains in the display.
To unlock both doors:
Press and hold tile upper oven CANCEL and Cook & Hold
pads for three seconds. OFF disappears from the display and
LOCK flashes while the doors are unlocking.
Important: The touchpads and oven doors cannot be locked
if the oven temperature is 400° F or above.
Fault Codes
BAKE or LOCK may flash rapidly in tile display to alert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press CANCEL pad. If BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes,
and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized
servicer.
Adjusting Sound Level
The factory default setting for sound is medium (MEd), but it
can be changed to low (LO) or high (HI). To change the
setting:
1. Press and hold Delay and upper oven CANCEL pads for
three seconds. A beep will sound. "bEEP" and the current
sound level CLO", "MEd" or "HI") will appear in the
display.
2. Press the Autoset pad to increaseor decrease the sound
level.
3. Wait four seconds and the new setting will be accepted.
4. If the Autoset pad is not pressed within 30 seconds, the
control will return to the existing setting.
Changing Temp °F/°C
The factory default setting for temperature is Fahrenheit. To
change the setting:
1. Press and hold the upper oven Bake and CANCEL pads
for three seconds. A beep will sound and the current
setting (°F or °C) will appear in the display.
9