Remove An Sfp Module From An Sfp Module Slot - Cisco PIX 520 - PIX Firewall 520 User Manual

Chapter 4 Connecting to the Switch
Step 4 Insert the SFP module into the slot until you
feel the connector on the module snap into
place in the rear of the slot.
Step 5
On fiber-optic SFP modules, remove the dust plugs from the optical ports, and store them for
later use.
Step 6 Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

Remove an SFP Module from an SFP Module Slot

Tip
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 2 Disconnect the cable from the SFP module, and insert a dust plug into the cable end.
Step 3
Unlock and remove the SFP module.
If the module has a bale-clasp latch, pull the
bale out and down to eject the module. If the
bale-clasp latch is obstructed and you cannot
use your finger to open it, use a small,
flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Step 4 Grasp the SFP module between your thumb and index finger, and carefully remove it from
the module slot.
OL-12761-02
For reattachment, note which cable connector plug is send (TX) and which is
receive (RX).
Follow these steps:

Remove an SFP Module from an SFP Module Slot

C a ta ly s
t E x p re
s s 5 2 0
S er ie s
1
C a ta ly st
E x p re ss
5 2 0
1
User Guide for the Catalyst Express 520 Switches
Se rie s
4-5