Installing Sfp Modules; Installing An Sfp Or Sfp+ Module - Cisco Catalyst 1000 Series Hardware Installation Manual

Switch Installation
Step 5
(Optional) Use the small sleeve for thin power cords. Use the small sleeve to provide greater stability for thin
cords. Detach the sleeve, and slide it over the power cord.
Figure 17: Sleeve Around the Power Cord
1
Step 6
Secure the AC power cord by pressing on the retainer.
Figure 18: Securing the Power Cord in the Retainer

Installing SFP Modules

See the switch release notes on Cisco.com for the list of supported SFP modules. Use only Cisco SFP modules
on the switch. Each Cisco module has an internal serial EEPROM that is encoded with security information.
This encoding provides a way for Cisco to identify and validate that the module meets the requirements for
the switch.
For information about installing, removing, cabling, and troubleshooting SFP modules, see the module
documentation that shipped with your device.

Installing an SFP or SFP+ Module

Before you begin
When installing SFP or SFP+ modules, observe these guidelines:
Sleeve for thin power
cords
Cisco Catalyst 1000 Series 24-Port and 48-Port Switch Hardware Installation Guide
2 AC power cord

Installing SFP Modules

27