Cisco PIX 520 - PIX Firewall 520 User Manual page 31

Chapter 2 Setting Up the Switch
Step 1 Make sure that nothing is connected to the
switch.
Step 2
Use the supplied switch power cable to
connect the switch to an AC power source.
Before proceeding to the next step, wait until
the SYSTEM LED stops blinking green and
becomes solid green. A solid green SYSTEM
LED means that the switch is operating
properly.
The ADMIN LED should be blinking green.
A blinking green ADMIN LED means that the
switch does not have an IP address yet.
Troubleshooting:
If the SYSTEM LED does not blink green,
does not turn solid green, or turns amber,
contact your Cisco representative or reseller.
The switch failed the power-on self-test
(POST).
OL-12761-02
You need the Category 5 Ethernet cable that is shipped with the switch.
•
You should disable any pop-up blockers or proxy settings in your browser
•
software and any wireless clients running on your PC or laptop.
Follow these steps:
Set Up the Switch (Existing Network)
SYST
ALRT
1
PoE 2
3
4
5
6
ADM IN
7
8
POW ER
OVER ETH ERN
ET
SY ST
SYST
ALRT
AL RT 1
PoE 2
3
4
Po E 5
6
ADMI N 7
POW ER
OVER ETH ERN
ET
AD MI N
User Guide for the Catalyst Express 520 Switches
Ca ta lys
t Ex pr es
s 52 0
Se rie s
1
8
Ca tal ys
t Ex pr es
s 52 0
Se ries
1
2-3