Stackwise Adapter Blanks; Sfp And Sfp+ Module Cable Specifications - Cisco Catalyst 3650 Series Manual

Appendix B Connector and Cable Specifications

StackWise Adapter Blanks

A StackWise adapter blank is installed in the stacking port if stacking is not specified at the time of
ordering the switch. The StackWise adapter blank is screwed into the stacking port and must be removed
and replaced by a StackWise adapter if the port is to be used for stacking.
StackWise adapter blank.
Figure B-12
1
2
3
1
2

SFP and SFP+ Module Cable Specifications

Each port must match the wave-length specifications on each end of the cable, and the cable must not
exceed the stipulated cable length. Copper 1000BASE-T SFP module transceivers use standard four
twisted-pair, Category 5 cable at lengths up to 328 feet (100 meters).
For cabling specifications, refer to the Cisco Transceiver Modules data sheet at:
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_data_sheets_list.html
OL-29734-01
StackWise Adapter Blank
StackWise adapter blank
Assembly screw
3 Cisco label
Catalyst 3650 Switch Hardware Installation Guide
Cable and Adapter Specifications
Figure B-12 shows a
B-7