Install The Switch On A Desk Or Shelf - Cisco PIX 520 - PIX Firewall 520 User Manual

Chapter 3 Installing the Switch

Install the Switch On a Desk or Shelf

Step 1
Locate the adhesive strip with the rubber feet in the accessory kit.
Step 2 Remove the four rubber feet from
the adhesive strip, and attach them
to the recessed areas on the bottom
of the unit. This prevents the switch
from sliding on the desk or shelf.
We strongly recommend that you
attach the rubber feet. Doing so
helps prevent airflow restriction
and overheating.
Step 3
Place the switch on the desk or shelf near an AC power source.
Step 4 Use the supplied switch power cable to connect the switch to an AC power source.
Step 5 Wait until the System LED blinks green and then turns solid green. A solid green SYSTEM
LED means that the switch is operating properly.
Troubleshooting:
If the SYSTEM LED does not blink green, does not turn solid green, or turns amber, contact
your Cisco representative or reseller. The switch failed the power-on self-test (POST).
OL-12761-02
Follow these steps:
1
s
rie NET
Se 0 ER ETH
52
s es
pr
Ex
st ly
ta
Ca
8
7
6
5
4
3
2
User Guide for the Catalyst Express 520 Switches

Install the Switch On a Desk or Shelf

OVER
ER POW
IN ADM
PoE
1
T
ALR
T SYS
3-7