Installing An Sfp Or Sfp+ Module - Cisco Catalyst 9200 Series Hardware Installation Manual

Installing a Compact Switch
Step 3
Guide the connected cables through the slots in the front of the cable guard and pivot the cable guide back to
the original position as shown in the following figure.
Step 4 Lock the cable guide in the installed position using the two 8-18 Phillips pan-head screws provided.
Figure 47: Switch with Cable Guide Installed
1

Installing an SFP or SFP+ Module

Before you begin
When installing SFP or SFP+ modules, observe these guidelines:
• Do not remove the dust plugs from the modules or the rubber caps from the fiber-optic cable until you
• To prevent ESD damage, follow your normal board and component handling procedures when connecting
Caution
Two 8-18 Phillips
pan-head screws
are ready to connect the cable. The plugs and caps protect the module ports and cables from contamination
and ambient light.
cables to the switch and other devices.
Removing and installing an SFP or SFP+ module can shorten its useful life.
Do not remove and insert any module more often than is absolutely
necessary.
-
Cisco Catalyst 9200 Series Switches Hardware Installation Guide

Installing an SFP or SFP+ Module

-
73