LAN Phone 101 User Manual Guide
16. [support] command
1.-print : display current SUPPORT values configurations.
2.-fstart: enable or disable fast start (support –fstart 0/1 , 0 for disable and 1 for enable.)
3.-tunnel: enable or disable H.245 tunnel function.(support –tunnel 0/1 , 0 for disable and 1
for enable)
4.-h245fs:set if open H.245 separate channel after fast start or not. (support –h245fs 0/1 , 0
for open and 1 for not.)
Note: When fast start function is enabled, if user wants to send DTMF message after
connection, LAN Phone will send out Q.931 message. (Please refer to 10.sysconf –keypad
command, which can only set keypad as q.931 message at this time)
17. [bureau] command
Type bureau can display commands below.
1. -print: display bureau line information and configuration.
2. -hold: set hold tone generation on or off. If other terminals support H.450 hold function, and
execute hold function when connecting with LAN Phone 101, user will hear hold tone from
LAN Phone 101. (0 for off ,1 for on)
Copyright (c) 2002 WellTech Computer Corporation
28
LAN Phone Ver. 112/502(Normal and PPPoE)
Document Ver. 1.7