Table of Contents
Advertisement
1. Press <Menu> and <UP/DOWN> to scroll to Base Settings.
2. Press <Select> and <UP/DOWN> to scroll to BS Default.
3. Press <Select> and enter the 4-digit system PIN (Default 4-digit system PIN: 0000)
4. Press <OK> to confirm the PIN.
5. Press <OK> to confirm the base default reset.
Note: If the PIN code is entered incorrectly, "PIN Invalid" will display.
Registration
8.3
IMPORTANT: When you purchase an iDECT Z10/Z10i system, all handsets are already
registered to the base, so you do not need to register them. Handset registration is only
necessary when you buy extra handsets or if a handset has become faulty.
can be registered to a
single base station.
If for some reason, the handset is not registered to the base station (<Antenna icon> is off),
register your handset according to the following procedure.
1.
Press and hold <PAGE> on the base station for about five seconds
into registration mode. (The base in use LED will flash.)
On the handset, press <Menu> and <UP/DOWN> to scroll to Registration.
2.
3.
Press <Select> and <UP/DOWN> to scroll to the base station number you want to register
to. (The handset can be registered to up to 4 different base stations at one time. If the
handset is already registered to a base that base number will be displayed in bold.)
4.
Press <Select> and enter the 4-digit system PIN.
5.
Press <OK> to confirm the registration attempt.
If the handset registration is successful, you will hear a confirmation tone and it will return to idle
mode and the <antenna icon> will stop flashing. The handset will automatically be allocated the
next available handset number.
This handset number is shown in the handset display in idle mode.
Up to five handsets
to put the base station
.
2
3
Advertisement
Table of Contents
