El (Erase Lamp) Board - Brother 8250P - FAX B/W Laser Printer Service Manual

1.22 EL (Eraser Lamp) Board
Only when you need to replace the EL board (which is attached with double-sided adhesive tape),
remove it according to the steps below.
(1) Make sure that the EL board harness is disconnected from the high-voltage power supply
PCB. (Refer to Section 1.15.)
(2) Make sure that the heat-fixing unit is removed.
(3) Peel off the EL board from the main cover and clear adhesive tape if remaining.
n n
Reassembling Notes
• When attaching a new EL board, bring the right end into contact with the boss provided on the
main cover.
IV - 43