Intel CORE 2 DUO E4000 - DATASHEET 3-2008 Datasheet page 69

Land Listing and Signal Descriptions
Table 25. Signal Description (Sheet 1 of 9)
Name
BPM[5:0]#
BPRI#
BR0#
BSEL[2:0]
COMP8
COMP[3:0]
Datasheet
Type
BPM[5:0]# (Breakpoint Monitor) are breakpoint and performance
monitor signals. They are outputs from the processor which indicate
the status of breakpoints and programmable counters used for
monitoring processor performance. BPM[5:0]# should connect the
appropriate pins/lands of all processor FSB agents.
BPM4# provides PRDY# (Probe Ready) functionality for the TAP
Input/
port. PRDY# is a processor output used by debug tools to determine
Output
processor debug readiness.
BPM5# provides PREQ# (Probe Request) functionality for the TAP
port. PREQ# is used by debug tools to request debug operation of
the processor.
These signals do not have on-die termination.
BPRI# (Bus Priority Request) is used to arbitrate for ownership of
the processor FSB. It must connect the appropriate pins/lands of all
processor FSB agents. Observing BPRI# active (as asserted by the
Input priority agent) causes all other agents to stop issuing new requests,
unless such requests are part of an ongoing locked operation. The
priority agent keeps BPRI# asserted until all of its requests are
completed, then releases the bus by de-asserting BPRI#.
BR0# drives the BREQ0# signal in the system and is used by the
processor to request the bus. During power-on configuration this
Input/
signal is sampled to determine the agent ID = 0.
Output
This signal does not have on-die termination and must be
terminated.
The BCLK[1:0] frequency select signals BSEL[2:0] are used to
select the processor input clock frequency.
possible combinations of the signals and the frequency associated
with each combination. The required frequency is determined by
Output
the processor, chipset and clock synthesizer. All agents must
operate at the same frequency. For more information about these
signals, including termination recommendations refer to
Section 2.7.6.
COMP[3:0] and COMP8 must be terminated to V
Analog
board using precision resistors.
Description
Table 16 defines the
on the system
SS
69