Thermal Specifications And Design Considerations; Processor Thermal Specifications; Thermal Specifications - Intel CORE 2 DUO E4000 - DATASHEET 3-2008 Datasheet

Thermal Specifications and Design Considerations

5 Thermal Specifications and
Design Considerations
5.1

Processor Thermal Specifications

The processor requires a thermal solution to maintain temperatures within the
operating limits as described in
outside these operating limits may result in permanent damage to the processor and
potentially other components within the system. As processor technology changes,
thermal management becomes increasingly crucial when building computer systems.
Maintaining the proper thermal environment is key to reliable, long-term system
operation.
A complete thermal solution includes both component and system level thermal
management features. Component level thermal solutions can include active or passive
heatsinks attached to the processor Integrated Heat Spreader (IHS). Typical system
level thermal solutions may consist of system fans combined with ducting and venting.
For more information on designing a component level thermal solution, refer to the
appropriate Thermal and Mechanical Design Guidelines (see
Note: The boxed processor will ship with a component thermal solution. Refer to
for details on the boxed processor.
5.1.1

Thermal Specifications

To allow for the optimal operation and long-term reliability of Intel processor-based
systems, the system/processor thermal solution should be designed such that the
processor remains within the minimum and maximum case temperature (T
specifications when operating at or below the Thermal Design Power (TDP) value listed
per frequency in
thermal capability may affect the long-term reliability of the processor and system. For
more details on thermal solution design, refer to the appropriate Thermal and
Mechanical Design Guidelines (see
The processor uses a methodology for managing processor temperatures which is
intended to support acoustic noise reduction through fan speed control. Selection of the
appropriate fan speed is based on the relative temperature data reported by the
processor's Platform Environment Control Interface (PECI) bus as described in
Section 5.4.1.1. The temperature reported over PECI is always a negative value and
represents a delta below the onset of thermal control circuit (TCC) activation, as
indicated by PROCHOT# (see
must be designed to take these conditions in to account. Systems that do not alter the
fan speed only need to
specifications.
To determine a processor's case temperature specification based on the thermal profile,
it is necessary to accurately measure processor power dissipation. Intel has developed
a methodology for accurate power measurement that correlates to Intel test
temperature and voltage conditions. Refer to the appropriate Thermal and Mechanical
Design Guidelines (see
Methodology for the details of this methodology.
The case temperature is defined at the geometric top center of the processor. Analysis
indicates that real applications are unlikely to cause the processor to consume
maximum power dissipation for sustained time periods. Intel recommends that
Datasheet
Section 5.1.1. Any attempt to operate the processor
Table 26. Thermal solutions not designed to provide this level of
Section
Section 5.2). Systems that implement fan speed control
the case temperature meets the thermal profile
ensure
Section 1.2) and the Processor Power Characterization
Section
1.2).
1.2).
Chapter 7
)
C
77