Transporting; Ignition System Check - HYOSUNG TE 50 B Owner's Manual

■
★
1. Make sure there is enough fuel in the fuel tank.
2. Check to see that the spark plug is not fouled.
Remove the plug and decarbon or replace it, if
necessary.
3. Make sure the fuel cock is clear. Also check
connected to the fuel tank cap is not clogged.
1. Remove the spark plug and reattach it to the
spark plug lead.
2. While holding the spark plug firmly against the
engine, push the starter switch with the
engine stop switch in the
the remote engine stop switch cap is installed
on the remote engine stop switch. If the igni-
tion system is operating properly, a blue
spark should jump across the spark plug gap.
If there is no spark, take your machine to you
authorized HYOSUNG dealer.
Engine stalls
position and
The 『 『 』 』 should be transported in the nor-
mal position, if possible. It may also be trans-
ported in the standing position, but the standing
position is not as stable as the normal position.
Before transporting the 『 『
from the carburetor as follows :
1. Turn the fuel cock lever to the OFF position.
2. Drain fuel from the carburetor into a suitable
container by loosening the carburetor drain
bolt.
3. When the fuel has drained completely, retight-
en the drain bolt.
40
』 』 , drain the fuel