Instruction For Remote Engine Stop Switch Lanyard Storage; To Use The Remote Engine Stop Switch - HYOSUNG TE 50 B Owner's Manual

The switch consists of a rubber cap fitted over a
plastic body. When the rubber cap is in place, the
engine can operate. When the rubber cap is
removed from the switch body, the engine cannot
be started. If the engine is running and the rubber
cap is removed by pulling the lanyard attached to
the cap, the engine will stop running.

To use the remote engine stop switch :

1. Fit the rubber cap on the engine of the lan-
yard over the remote engine stop switch
body located on the rear end of the vehicle
as shown.
2. Put your fingers through the loop at the
other end of the lanyard.
3. With the lanyard fastened to the vehicle and
to your hand, follow after the moving vehi-
cle. If you notice any driving hazard or
unsafe situation, pull the lanyard forcefully
so that the rubber cap comes off.
This will activated the remote engine stop
switch, stopping the vehicle s engine.
『 『 』 』
『 『 』 』
The lanyard may be stowed on the 『 『
when, in the judgement of the parents, the rider
has developed sufficient skills to be able to safe-
ly operate the vehicle without parental use of the
lanyard.
For storage of the lanyard, follow the instruc-
tions below :
13
『 『 』 』
』 』