Tire Tread Condition; Tire Replacement; Tire Pressure; Tube Tire Repair - HYOSUNG TE 50 B Owner's Manual

◉
◉
A low pressure gauge is provided in tool kit under
the seat, o you can measure the air pressure in
S
your 『 『 』 』 tires. Check the air pressure in all
tires before each use of the vehicle. Improper air
pressure can affect handling, maneuverability,
traction, tire life and rider comfort. Be sure that
the tires are inflated to the pressures shown
below. Tire pressure should only be measured or
adjusted when the tires are cold, or misleading
measurements can result.
COLD TIRE PRESSURE
FRONT
REAR
25 KPa
0.25 ㎏/㎠
3.6 psi
25 KPa
0.25 ㎏/㎠
3.6 psi
◉
Air in the low-pressure tube tire of this vehicle is
sealed by the contact surfaces of the inner wheel
rim and the tire bead. If either the inner wheel rim
or tire bead is damaged, air may leak. Be
extremely careful not to damage these sections
when replacing tires.
When breaking the tire bead loose from the
wheel, be extremely careful not to damage the
inner wheel surface or the tire bead.
It is very important to use the proper tools when
repairing or replacing tires, to prevent damage to
the tire bead or wheel rims. We highly recom-
mend that you have such work done by your
HYOSUNG dealer or a qualified tire repair sta-
tion.
◉
Should a leak or flat tire occur due to a puncture,
the tire may be repaired using a plug type patch.
If the damage is from a cut, or if the puncture
cannot be repaired using a plug, the tire should
be replaced. When operating your 『 『
areas where transportation or service facilities are
not readily available, it is strongly recommended
that you bring a plug type repair kit and a tire
pump with you.
35
』 』 in