Front And Rear Wheel Removal; Footrest Height Adjustment; Tighten Toeque - HYOSUNG TE 50 B Owner's Manual

The slack in the drive chain to 5~15mm
(0.197~0.591 in).
If exceed 15mm (0.591 in) of the drive chain
slack, replace the drive chain with a new one.
③
This vehicle is equipped with a footrest lower
bolts ①.
To adjust height of the footrest, perform the fol-
lowing :
1. Remove the footrest screws ②.
2. Remove the footrest bolts ③.
3. Remove the footrests ④, right and left.
4. Install the footrest lower bolts ①.
5. Install the footrests ④, right and left.
6. Tighten the footrest bolts ③.
7. Tighten the footrest screws ②.
②
④
①
①
1. Place the vehicle on level groud and set the
parking brake.
2. Loosen the three wheel nuts ① on the wheel
to be removed.
3. Lift up the front or rear end of the vehicle by
placing a jack or block under the axle or
frame.
4. Remove the three wheel nuts.
5. Remove the wheel. To reinstall the wheel,
reverse these steps.
Front and Rear
wheel nut
37
25 N∙m
(2.5㎏∙m)