Messages And Responses - Kyocera FineCam SL300R Instruction Manual

Problem
The camera gets hot.
The caution LED
flashes slowly.
The caution LED
flashes quickly.
The camera will not
focus. The shooting
mark flashes.
The picture came out
completely white.
I can't rotate or protect
the image or specify
DPOF settings.

Messages and Responses

Message
MEMORY CARD
FULL
NO CARD
WRITE PROTECT
CARD ERROR
or
UNSUPPORTED
FORMAT
NO IMAGE
Cause
A strong current flows through the
camera when the LCD monitor is used
so the camera gets hot if the LCD
monitor is used for an extended
period.
The flash is charging.
This is the camera shake warning.
The shutter speed is slow.
The subject is a type that is not suited
to autofocus. ( p.3-2)
The image is overexposed.
The SD memory card is write-
protected.
Cause
There is not enough recording space
available on the memory card.
There is no memory card inserted.
The SD memory card is write-
protected.
You are using a card that was
formatted on another device.
The format of the memory card is not
compatible with this camera.
The card is not inserted correctly.
Nothing is recorded on the memory
card.
Solution
While this is not a fault, you should
leave the camera for a time before
using it again.
Briefly take your finger off the shutter
release button and wait.
Place the camera on a stable surface
to take the picture.
Use focus lock to focus on a strongly
contrasting part of the subject, then
compose the shot and take the
picture. ( p.3-2)
Set LONG EXP to OFF or reset the
camera settings.
Release the write-protection for the
card. ( p.1-4)
Response
Insert a new memory card or erase
some unwanted images. Alternatively,
changing the image size or quality
may enable you to take the picture.
Insert a memory card.
Release the write-protection for the
card ( p.1-4) or use another memory
card.
Format the memory card in the
camera. ( p.6-5)
Insert a new memory card or format
this memory card.
Re-insert the memory card.
Insert a memory card that has been
used to take pictures.
7
7-3