Working With Adapters - IBM 8686 - Eserver xSeries 360 Hardware Maintenance Manual

3. Press the bezel release latches at the top edge of the bezel, and pull the top of
4. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store

Working with adapters

The following illustration shows the location of the six hot-plug PCI-X adapter
expansion slots, the Remote Supervisor Adapter slot, and their related components
on the system board.
PCI-X slot 1
PCI-X slot 2
PCI-X slot 3
PCI-X slot 4
PCI-X slot 5
PCI-X slot 6
This server supports the following adapter configurations:
v Bus A (hot-plug)
v Bus B (hot-plug)
To the right of PCI-X slot number 1 (as viewed from the front), there is a 33 MHz
64-bit slot dedicated to the Remote Supervisor Adapter.
Attention: For proper cooling and airflow, replace the top cover before turning
on the server. Operating the server for extended periods of time (over 30
minutes) with the top cover removed might damage server components.
the bezel slightly away from the server.
the bezel in a safe place.
Remote
Supervisor
Adapter slot
(J40)
– Four 66 MHz 64-bit PCI-X adapters (slots 3 through 6)
– Two 66 MHz 64-bit PCI adapters (slots 3 and 4)
– Four 33 MHz 64-bit PCI adapters (slots 3 through 6)
– One 133 MHz 64-bit PCI-X adapter (slot 1)
– Two 100 MHz 64-bit PCI-X adapters (slots 1 and 2)
– Two 66 MHz 64-bit PCI-X adapters (slots 1 and 2)
– Two 66 MHz 64-bit PCI adapters (slots 1 and 2)
– Two 33 MHz 64-bit PCI adapters (slots 1 and 2)
PCI attention LED
PCI power LED
73
Installing components