IBM 8686 - Eserver xSeries 360 Hardware Maintenance Manual page 93

3. Pull out the media tray release knob at the left of the CD-ROM drive and slide
the media tray out the front of the server.
Narrow ribbon
cable
Media tray
Media interposer
card
CD-ROM drive
retention spring
4. To detach the diskette drive from the media tray:
a. Unplug the narrow ribbon cable between the media interposer card and the
diskette drive where it plugs into the diskette drive.
b. Release the diskette drive retention spring on the right side of the tray, lift up
the right side of the diskette drive, and separate the drive from the alignment
pins on the tray.
c. To attach the replacement diskette drive to the tray, reverse these steps.
5. To detach the CD-ROM drive from the tray:
a. Release the CD-ROM drive retention spring on the left side of the tray and
slide the CD-ROM drive toward the front of the tray. As you remove the
drive, it unplugs from the media interposer card.
b. To attach the replacement CD-ROM drive to the tray, reverse these steps.
6. Side the tray into the bay and press the media tray release knob to secure it to
the frame.
7. Reconnect the wide cable between the media interposer card and the hard disk
drive backplane.
8. If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation" on page 95.
Diskette drive
Diskette drive
retention spring
CD-ROM drive
83
Installing components