IBM 8686 - Eserver xSeries 360 Hardware Maintenance Manual page 59

Installing Novell NetWare ASM device drivers: Complete the following steps to
install the ASM device drivers for the Novell NetWare operating system:
Note: If IBM Netfinity Director, IBM Director, or IBM Netfinity Manager is running on
the server, stop the system-management application before proceeding.
1. From a system console session, type one of the following commands:
v If the installation is from a diskette, type:
LOAD A:\NETWARE\SETUP
(where A is the drive letter assigned to the diskette drive).
Press Enter.
v If the installation is from a CD, type:
LOAD D:\DD\NETWARE\SETUP
(where D is the drive letter assigned to the CD-ROM drive).
Press Enter.
2. Follow the instructions that appear in the window.
3. Go to "Configuring the remote control password" on page 50.
Installing SCO UnixWare ASM device drivers: Choose one of the following
methods to install the SCO UnixWare ASM device drivers.
Note: If IBM Netfinity Director or IBM Director is running on the server, stop it
before proceeding.
v Complete the following steps to use the SCO UnixWare package utility:
1. Open a shell prompt.
2. Type scoadmin and press Enter.
3. Click Application Installer.
4. Click to access the diskette or CD-ROM drive (for example, DISK_A or
CD-ROM_1); then, install the package file that displays.
5. Continue with "Configuring the remote control password" on page 50.
v Complete the following steps to use the interactive installation from a shell
prompt:
Note: The commands in the following steps are case-sensitive.
1. Open a shell prompt.
2. If the installation is from a diskette, type:
pkgadd -d diskette1
3. If the installation is from a CD, type:
pkgadd -d cdrom1
4. Continue with "Configuring the remote control password" on page 50.
v Complete the following steps to use the non-interactive installation from a shell
prompt:
Note: The commands in the following steps are case sensitive.
1. Open a shell prompt.
2. If the installation is from a diskette, type:
pkgadd -d diskette1 -q-p-n uw7advmg
3. If the installation is from a CD, type:
pkgadd -d cdrom1 -q-p-n uw7advmg
4. Continue with "Configuring the remote control password" on page 50.
49
Configuration