IBM 8682 - Eserver xSeries 350 Hardware Maintenance Manual page 112

Note: The System Error LED will also be on.
Diagnostic Panel LED
PCI A LED on
PCI B LED on
PCI C LED on
PS1 LED on
PS2 LED on
PS3 LED on
SP Bus on
Event Log
Non Red
TEMP LED on
102
IBM xSeries 350 Type 8682: Hardware Maintenance Manual
FRU/Action
1. Check System Error Log for additional information.
2. PCI card in slot 1. See "System board component locations" on page 42
3. Remove all PCI adapters from slots 1-6.
4. Replace failing PCI adapter.
5. System Board.
1. Check System Error Log for additional information.
2. PCI card in slots 2-4. See "System board component locations" on page 42
3. Remove all PCI adapters from slots 1-6.
4. Replace failing PCI adapter.
5. System Board.
1. Check System Error Log for additional information.
2. PCI card in slots 5-6. See "System board component locations" on page 42
3. Remove all PCI adapters from slots 1-6.
4. Replace failing PCI adapter.
5. System Board.
1. Check the DC Good LED on power supply 1. If off, replace power
supply 1.
2. Power Backplane.
1. Check the DC Good LED on power supply 2. If off, replace power
supply 2.
2. Power Backplane.
1. Check the DC Good LED on power supply 3. If off, replace power
supply 3.
2. Power Backplane.
1. SP Bus card.
2. System Board.
Not implemented at this time.
1. Check PS1, PS2, and PS3 LEDs and take the actions for those
indicators.
2. See "Diagnostic panel error LEDs" on page 101
1. Ambient temperature must be within normal operating specifications.
See "Features and specifications" on page 3
2. Ensure fans are operating correctly.
3. Examine System Error Log.
a. DASD over recommended temperature (DASD LED also on)
1) Overheating hard drive
2) DASD Backplane
3) System Board
b. System over recommended temperature for CPU X (where X is CPU 1,
2, 3, or 4) (CPU LED also on)
1) CPU X