Removing The Cover And Bezel - IBM 8676 - Eserver xSeries 335 Installation Manual

v Take additional care when handling devices during cold weather. Heating reduces

Removing the cover and bezel

Complete the following steps to remove the cover and bezel:
1. Read the safety information beginning on page v, and "Installation guidelines" on
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Lift the cover release latch. The cover slides to the rear approximately 13 mm
4. Slide the cover back, and lift the cover off the server.
5. Press in on the USB option tray (below hard disk drive bay 1) to release it and
6. Press on the bezel retention tabs on the top, right side and bottom of the server,
8
IBM xSeries 335 Type 8676: Installation Guide
indoor humidity and increases static electricity.
page 7.
cords; then, disconnect all external signal cables from the server.
(0.5 inch).
Attention: To ensure adequate cooling and airflow, do not operate the server
with the cover removed. Operating the server with the cover removed might
damage server components.
slide the tray out until it stops; then, press the retention clip at the bottom rear
of the tray and remove the tray from the server.
Note: You need to remove the USB option tray and the bezel only if you are
installing a non-hot-swap hard disk drive. It is not necessary if you are
installing other options in the server.
and pull the bezel directly away from the server.
Captive screws
Bezel retention
tabs
USB option tray
Bezel
retention
tabs
Retention
clip