Standby Mode - IBM 8676 - Eserver xSeries 335 Installation Manual

v You can press the power-control button to start an orderly shutdown of the
v If the operating system stops functioning, you can press and hold the
v If the Wake on LAN feature turned on the server, the Wake on LAN feature can
v If your operating system supports the system-management software for an
v You can remove all power from the server by disconnecting the server from the

Standby mode

When the server is connected to an ac power source but has not been turned on, it
is in Standby mode. When the server is in Standby mode, the operating system is
not running, and all core logic except for the service processor is shut down. The
power-on LED flashes to indicate that the server is in Standby mode. The server
can respond to requests from the service processor, such as a remote request to
turn on the server.
To put the server into Standby mode when the server is turned on, shut down the
operating system (see your operating-system documentation), and press the
power-control button.
You can also put the server into Standby mode through a request from either the
integrated system management processor (using IBM Director) or an optional
Remote Supervisor Adapter. For details, see the documentation that comes with the
option.
30
IBM xSeries 335 Type 8676: Installation Guide
operating system, if your operating system supports this feature, and turn off the
server.
power-control button for more than 4 seconds to turn off the server.
turn off the server.
optional Remote Supervisor Adapter, the system-management software can turn
off the server.
ac power source.