8. If you have other options to install, install them now. Otherwise, continue with
Completing the installation
This section describes how to complete the installation.
Installing the cover and bezel
Complete the following steps to install the server cover and bezel:
1. Position the internal cables so they do not interfere with the cover installation.
2. Position the cover on top of the server and slide it forward. Press down on the
are tight. Do not overtighten the screws by using excessive force.
"Completing the installation".
Attention:
Before sliding the cover forward, make sure that all the tabs on
both the front and rear of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
cover latch. The cover slides forward into position. Ensure that the cover
Heat sink
Microprocessor 2
Microprocessor 2
VRM
Chapter 2. Installing options
21