Server Power Features; Turning On The Server; Turning Off The Server - IBM 8676 - Eserver xSeries 335 Installation Manual

C2T IN connector: Use this connector to connect to the C2T OUT connector of
another xSeries 335 or xSeries 330 server.
If you have an optional Remote Supervisor Adapter (system-management adapter)
installed in PCI slot 1, your server has additional connectors and LEDs. See the
documentation that comes with the adapter for more information about these
connectors and LEDs.

Server power features

When you connect the server to an ac power source, the server goes into Standby
mode. After approximately 20 seconds, the power-control button becomes active,
and you can turn on the server and start the operating system by pressing the
power-control button. The following section describes other ways in which the
server can be turned on.

Turning on the server

After the server is connected to an ac power source, it can be turned on in any of
the following ways:
v You can press the power-control button.
v If a power failure occurs while the server is turned on, the server will restart
v If your operating system supports the system-management software for an
v If your operating system supports the Wake on LAN feature, the Wake on LAN

Turning off the server

Some operating systems require an orderly shutdown before you turn off the server.
See your operating-system documentation for information about shutting down the
operating system.
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
The server can be turned off in any of the following ways:
automatically when power is restored.
optional Remote Supervisor Adapter, the system-management software can turn
on the server.
feature can turn on the server.
Chapter 3. Server controls, LEDs, connectors, and power
29